メーカー

Kiwi レギュレーター

  • 商品型番: From_Kiwi
  • 重量: 0.07 kg
  • メーカー: Fromeco

(画像用) 問い合わせる

¥8276  ¥7333
特価: ¥6621
値引額: 20% off

カートに追加:

The Kiwi pass through regulator is a regulator that is designed specifically for helicopter use.  The Kiwi can be thought of both a regulator and a Power Buss type unit.  Designed for use with any battery with a Voltage under 10 volts.  It is recommended that a battery no higher than 8.4  be used with the Kiwi due to its designed purpose.   Before you purchase a Kiwi it is strongly recommended by Fromeco that you read Fromeco's Kiwi PDF document found here. Kiwi PDF You will need Adobe Acrobat 6.0 or higher to view this document.

 The Kiwi is designed to help pilots squeeze every last inch out of performance from there servos at higher voltages.   It is also the perfect unit to allow for the unregulated Cyclic control voltages using a LiFePO4 battery pack such as the Iron Corps, and Iron Corps Extreme A123.

  Kiwi at a glance:

  • Deans input connector.
  • 4 Ports, usable at either Raw Battery Voltage, or Regulated at 5 volts.
  • 5 Male/Male JR jumpers for connection to RX, 1 jumper for Switch.
  • Switch not included must be purchased separately.
  • Designed for use on batteries 8.4 volt and lower, Please read Kiwi PDF, for warnings and clarification on unit installation.

Electrical Specs:

Max Voltage10 Volts max *Batteries w/voltage higher than 8.4 should not be used
Operating VoltageRegulated out put 5 volts, for Gain, Rudder, Throttle, and support equipment only, not to be used on Cyclic

Size/Mass:

Length65 mm
Width25 mm
Height18 mm
Mass31 g


この商品は 2008年12月05日(金) に登録されました。

言語

(画像用) Japanese  (画像用) English  

オンラインのお客様

現在 28 人のゲスト がご来店中です。
IPアドレス: 18.213.4.140
Copyright © 2024 HELITECH JAPAN. Powered by Zen Cart